The brand new Cree900s are amazing auxillary LED lights..... small design that is perfect for motorcycles ( just a 40mm lens). They are 10W 900 Lumen per light, 6000k bright white lights that will give you greater illumination AND get you seen by cagers!
They draw only 0.66A per light, so they will work on any motorcycle, regardless of your bike's electrical capacity. They are an easy to fit design, with a stainless steel bracket, adjustable for angle.
They are rated to IP68..... dunk them in a pail of water..... no worries. Ride them through the river.... no problem. So a little thunderstorm? They "laugh"at rain! They are Cree LED, so they will last 50,000 hrs ( 8 years of constant use )
They are constructed with an all alloy housing and high quality
stainless brackets, meaning they are built to last through the very
worst of road conditions.
Cree900 LED Aux Lights are available in -
10° SPOT BEAM - Ideal linked to High Beam for extra light 'down road'
50° WIDE BEAM - Low beam supplement / Daytime Running / Fog lighting
LED type: Genuine Cree 10W LED, 6000K white.
Input : 9-50V DC
Power Consumption: 10W
Lens : Virtually unbreakable PMMA lens, light transmittance >93%, heat resistance +90C
Housing: Rugged Diecast Aluminum Housing (Optimum durability and heat dissipation)
Bracket : Stainless Steel
Connection: Deutsch Connector DT-2 pin series Quick Release
IP Rating: IP68 (Manufacturer Standard: submersible under water up to 1.1 Meter for 24 hrs.)
Operating Temp.: -40 to +105C
Light Output : 900 Lumens per light pod
Lifespan: Extreme long lifetime up to 50,000 hrs
NET Weight: 500 gr
Reverse Voltage Protected
Warranty: 1 year
Environmentally Friendly: Contains NO mercury, lead or other heavy metals.
- 1 Cree900 LED light, either in wide 50 degree flood, or narrow 10 degree spot with Deutsch quick-disconnect end
- 2 wiring harnesses!!!
- First one has Deutsch Quick disconnect connectors with 150cm of cable for easy wiring, (cable has quick disconnects to each light pod, ON/OFF Panel mount switch ... can be replaced with another switch), 15A fused battery harness)
- AND second harness comes with everything you need to wire two CREE900 LED pods, including relay, and lighted on/off switch for handlebar mounting.---
- Wiring harnesses are included ONLY when 2 light pods are ordered. If only one light is ordered, only the one light pod will be shipped. If you are looking for a pair of lights, please order quantity 2. You can mix them if you want.... one flood and one spot.
- Installation guide
For the ultimate in connectivity, consider using either our Fuzeblock.com fuseblock or Rowe Electronics PDM60 and keep the spaghetti of wires off your battery and allow the lights to be turned on/off with your ignition, rather than direct attach to the battery allowing anyone to turn them on when you are away from the bike.